Call: 0845 519 4652 or Your enquiry |
| CLEAN HEAT UK |
Competitive Prices Fast Response Competent Engineers Sound Reputation |
| 506878 |
| Tel: 0845 519 4652 |
 |  |  |  |  |  |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
| |
 |
|
Power Flushing
If you are experiences any of the following symptoms then the chances are
your central heating system is in need of a forced cleaning process commonly
known as Power Flushing
Power flushing is a highly effective cleansing operation which works by
pumping water at a much higher velocity than usual through the heating
system, to loosen and immobilize harmful corrosion deposits and suspend
them in the rapidly moving water.
The process is made more effective by specialist cleansing chemicals and an
instantaneous flow reversal device which creates turbulence in the radiators to
optimize “pick up”.
Once loosened, the unwanted debris is purged from the system with clean
water. At the end of the flushing process the system contains fresh clean
water, and reinstatement of the system to normal operation takes only a few
minutes.
During the process, radiators are individually flushed without removing or
disconnecting them from the system by directing the full output of the pump
through each radiator separately.
The objective is to restore systems with circulation and boiler noise problems
(caused by sludge and corrosion deposits) to optimum operation. Power
flushing removes these deposits and the problems that
they cause.
Clean Heat UK uses the latest equipment and chemicals to restore your
heating system. We constantly analyze the system before, during and after
the cleaning ensuring the process was successful
Under part L of the Building Regulations Power Flushing should also be carried
out to all new systems and before fitting a new boiler, it is important when
installing new boilers into old systems that all the sludge is first removed from
the system or this could accumulate in the new boiler and lead to premature
failure.
If you are experiences any of the following symptoms then the chances are
your central heating system is in need of a forced cleaning process commonly
known as Power Flushing
- Heating system slow to warm up
- Combination boilers being unable to deliver constant hot water
- Unusual system or boiler noises
- Repeated pump failure
- Radiators need frequent bleeding
- Radiator water black with iron oxide sludge
Power flushing is a highly effective cleansing operation which works by
pumping water at a much higher velocity than usual through the heating
system, to loosen and immobilize harmful corrosion deposits and suspend
them in the rapidly moving water.
The process is made more effective by specialist cleansing chemicals and an
instantaneous flow reversal device which creates turbulence in the radiators to
optimize “pick up”.
Once loosened, the unwanted debris is purged from the system with clean
water. At the end of the flushing process the system contains fresh clean
water, and reinstatement of the system to normal operation takes only a few
minutes.
During the process, radiators are individually flushed without removing or
disconnecting them from the system by directing the full output of the pump
through each radiator separately.
The objective is to restore systems with circulation and boiler noise problems
(caused by sludge and corrosion deposits) to optimum operation. Power
flushing removes these deposits and the problems that
they cause.
Clean Heat UK uses the latest equipment and chemicals to restore your
heating system. We constantly analyze the system before, during and after
the cleaning ensuring the process was successful
Under part L of the Building Regulations Power Flushing should also be carried
out to all new systems and before fitting a new boiler, it is important when
installing new boilers into old systems that all the sludge is first removed from
the system or this could accumulate in the new boiler and lead to premature
failure.